What is included?

 

Control box

Display unit

Water geyser sensor

Collector temperature sensor and extension

Water leak detector and extension

12V link cable

Screws

Alarm cable

 

Use as a geyser timer

Clear display of water temperature, time, day, heating mode and malfunction conditions.

Auto or manual heating.

Easy temperature setting to your requirements (30 - 65°C) factory default is 55°C.

Four different temperature settings.

Daily programmable timer with four time settings.

Error conditions alert by warning code E1 to E7.

Electronic thermostat with mechanical thermal cut-out at 90°C.

 

Use as timer on a thermosyphon solar system

Clear display of water temperature, time, day, heating mode and malfunction conditions on solar system and geyser.

Auto or manual heating.

Easy temperature setting to your requirements (30 - 65°C) factory default is 55°C.

Four different temperature settings.

Daily programmable timer with four time settings.

Error conditions alert by warning code E1 to E7.

Electronic thermostat with mechanical thermal cut-out at 90°C. Please note the cut-out temperature for solar systems expected to reach temperatures above this temperature.

Use as timer and differential control on pumped solar system

Clear display of water temperature, time, day, heating mode and malfunction conditions on solar system and geyser.

Auto or manual heating.

Easy temperature setting to your requirements (30 - 65°C) factory default is 55°C.

Four different temperature settings.

Daily programmable timer with four time settings.

Error conditions alert by warning code E1 to E9.

Electronic thermostat with mechanical thermal cut-out at 90°C. Please note the cut-out temperature for systems expected to reach temperatures above this temperature.

Differential controller 12V and 220V systems.

 

Technical Parameters

Operating voltage 230VAC / 50HZ.

Main Relay contact rating 30AMP (Max 4KW).

Secondary relays pump and solenoid 5Amp.

Operating voltage range 160V – 250V AC.

Earth leakage protection at 25MA action time = 0,1 second.

Temperature display range 0 - 99°C (“-5” when below -5°C “EA” when above 99°C).

High temperature warning above 84°C.

Temperature setting ranges 30 - 65°C (heating water electrically).

Heat failure – when increase at a rate of less than 4°C per hour.

Electronic thermostat with mechanical thermal cut-out at 90°C.

Dry heat detection – empty cylinder.

Temperature tolerance ± 2%.

Temperature differential setting 1°C.

Switching differential 6°C.

2nd temperature probe for solar.

Solar differential 7°C.

Temperature probe failure detection for both collector and tank.

Temperature probe range for geyser is -30 to + 130°C.

Temperature probe range for collector is -30 to + 260°C.

Isolate both L + N when in off state.

Collector antifreeze protection at 5°C